As hard as I try to avoid it, every now and then I need to mill a small part on the router table. I’ve learned the hard way that you should never hold that part by hand, for three good …
A tenon should be one-third the thickness of a rail—at least, that’s what an old rule of thumb recommends. A 3/4″ board should have 1/4″ tenons, for example. But what about a [...]
Separate, sort, and see your collection With just five different parts to make, this easy-to-build caddy accommodates bits with both 1/2″ and 1/4″ shafts. It can be customized to [...]
To mark the exact center of a board, I measure an equal distance from both ends and make two marks. This distance is just an approximation—it doesn’t matter if it’s longer or shorter than exactly [...]
The price of good turning tools can be pretty steep. Since most of the better lathe tools can be purchased without a handle, put your money where it counts—in the steel, not the handle. After [...]
Make bent laminations on a big scale. One sweeping curve, 18-ft. long: that’s the essence of this dramatic stand. Making up that curve are dozens of thin pieces of construction-grade redwood, all [...]
Re-sawing a board is tricky. Most blades drift, so that you must angle the board to get a straight cut. Standard bandsaw fences can’t be angled to compensate for drift, so many folks use a [...]
Plus 9 useful tips for making any large-profile molding. If adding a bar is on your list of home improvements, you know that its large, contoured front rail is an essential element. Commercially [...]