Crown Molding Restoration, Part 3

After completing step (F), I used a gouge to hollow out the cove portion of the molding. I selected a gouge with a sweep that matched the cove radius and carefully shaved the wood in the [...]

Crown Molding Restoration, Part 2

Read part 1 After allowing the glue to set, I carefully removed the clamped molding from the guitar maker’s vise. At this point, I removed excess wood from the glued-up block using a bandsaw to [...]

Crown Molding Restoration, Part One

A few months ago, I restored a tall case of drawers in green. While the piece was not old, antique, or of substantial emotional value, it was still quite practical as it was tall and had several [...]

Edge-Knot Repair

Filling knots with colored epoxy usually works quite well, but sometimes the void is in a spot that’s difficult to fill, like the edge of a board. Here’s how to do it. First, apply some paste wax [...]

Hand Plane Restoration

Bringing an old hand plane back to life is simple to do, and will yield a top-not tool. When I build a project, I use a variety of “fancy” tools (readers’ words, not mine). Lie-Nielsen, [...]

Clamps for Delicate Work

Most of the clamps in our woodworking arsenal are designed to produce tons of pressure per square inch. While we use them to hold pieces over the workbench, close joints, or keep glued parts from [...]

page 1 of 2

Start typing and press Enter to search