It’s just like sawing a cove molding, but now the wood is round. “You’re kidding me!” That’s everybody’s first reaction when I tell them that I’ve figured out a way to make a bowl on the table [...]
The limited crosscut capacity of my cabinet saw made it a challenge to cut wider boards, so I designed an infeed table that hangs on a wall when not in use and quickly and securely attaches to [...]
Tool: Whiteside Plus by Dimar Industrial Saw Blades Shop Now Manufacturer: Whiteside MSRP: $76+ I had the opportunity to spin the newest blades from Whiteside Plus by Dimar. I thoroughly [...]
Flying Sawdust Last summer, due to the heat, I covered my portable saw with a canvas tarp and retreated to the cooler air inside my basement shop. For two months, the saw sat under the shed [...]
Even with a zero-clearance throat plate in my tablesaw, a thin cut-off slips through now and then. These pieces can clog a vacuum hose or damage the blades of a dust collector. I made a trap to [...]
Resawing can be a wild ride. You never know exactly what’s going to happen when you cut open a board! Just getting your tablesaw or bandsaw to work right can be an adventure, too. Resawing [...]
Hoisting heavy sheets of plywood and MDF onto my tablesaw is not my idea of workshop fun. That’s why I devised this pivoting rack— and began storing my sheet stock vertically. The rack’s frame [...]
I designed an outfeed support for my table saw that doesn’t take up any floor space. It’s made of plywood, hardwood and a store-bought roller. Three main design features enable it to work well. [...]
Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the [...]
Runaway Router My first router, a 1968 Stanley, was a heavy, single-speed machine. I remember it well because of what happened the very first time I used it. I chucked up a Roman ogee bit and [...]
I use lots of wedges in my shop, sometimes as disposable clamp pads for tricky glue-ups or for general shimming chores. Sometimes they’re incorporated into a project, as when making wedged [...]