How do you support an uneven piece on the drill press? Make something that’s the opposite shape, of course.
After making 60 of these knobs, I realized that the directions didn’t include any advice on drilling the holes for mounting them.
My tablesaw was still angled at 15°—the same angle as the bevels on the knobs. I grabbed a board from the scrap bin that was about the same width as the knobs and about 12″ long. I stood the piece on edge and made the two bevel cuts you see here. I cut a short piece from the board and placed it between two boards clamped to the drill press table. I marked the center of one knob, fine-tuned the position of the boards and fence, and merrily drilled away. –Steve Keller
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.