Archives

Bench grips are handy for holding parts above the bench for routing, sanding or finishing.  To make them, just cut some wood and rubber shelf liner into 2″ to 3″ squares. Glue the [...]

Good light is a must in every workshop, but sometimes I need a little extra light in just the right place. To make my light/magnifier more portable, I drilled a hole in a handscrew to fit the [...]

Instead of measuring for my circular saw’s offset each time I need to make a cut, I use a modified edge guide. I screwed two 3/4″ x 3/4″ x 12″ hardwood blocks to the front and [...]

Let’s face it: running a twisted board through the planer doesn’t make it flat. The board will still be twisted when it comes out. The trick is to use a sled that prevents the board from rocking [...]

Planer-Puss After my friend Jason and I purchased a truckload of rough lumber, we headed for his garage workshop to plane the boards before divvying them up. All of Jason’s tools are on mobile [...]

To support a large panel while I drilled holes in the edge for dowels, I added a second sliding clamp jaw to a pipe clamp and clamped it to the edge of my workbench. -Steve Keller…

On a crosscut sled, the fence must be absolutely square to the blade. Here’s a super-accurate method of testing for square. It makes errors easier to detect by magnifying them by a factor of [...]

My crosscut sled is my “go-to” jig for precise, square cuts. Recently, I added this self-adhesive tape scale – called Peel-n-Stick Ruler Tape – that makes it even more efficient. You [...]

Countersink first, drill the pilot hole second. That may sound backward, but it’s the easiest way to ensure a perfect countersink.

My simple tenoning jig produces flawless tenons in minutes— even haunched tenons. The jig consists of a sled with a glued-on support block and a screwed-on sacrificial backstop. The sled and [...]

Flying Sawdust Last summer, due to the heat, I covered my portable saw with a canvas tarp and retreated to the cooler air inside my basement shop.  For two months, the saw sat under the shed [...]

Spring clamps are easily converted to miter clamps by adding swivel jaws. Remove the vinyl tips, and then hacksaw a 1/2″ long slot down the center of the metal jaws. Use needle-nose [...]