Archives

An ideal project for learning how to make a bent lamination. A Mouse needs a nice home too, doesn’t it? At least, that’s what a friend had in mind when she asked me to design a little house [...]

Egg-oh! My fiancé and I planned an April wedding. To celebrate our marriage, I decided to turn a very special Easter egg. In addition to segmented rings of maple and ebony, this egg would have a [...]

Planing or scraping parts with angled or mitered ends is tricky. Bench dogs will damage a crisp corner, and clamps get in the way. To hold the work, I use an over-sized bench hook with a new [...]

My shop may appear rustic, but you won’t find a dirt floor or antique machinery inside. Editor’s note: This article originally appeared in American Woodworker #146. In fact, my friends all [...]

A coping sled is a must-have accessory for router table work. It helps you hold a narrow piece, such as a door rail, perpendicular to the fence and backs up the cut to prevent blowout. At least, [...]

This light-duty clamp is ideal for small parts-and easy to make by the dozen. All you need are a couple wood scraps, a rubber band, and a short piece of dowel rod. You can vary the pressure by [...]

Even with a zero-clearance throat plate in my tablesaw, a thin cut-off slips through now and then. These pieces can clog a vacuum hose or damage the blades of a dust collector.  I made a trap to [...]

New hardware is often way too shiny for my taste, so I chemically “age” it. If the metal is raw steel, I use standard gun bluing. But if it’s plated with zinc, I turn to Super Blue, a [...]

Chisels don’t wait to get dull until you’ve finished a job—do they? The trick is to keep them sharp while you’re working. Rather than pull out my stones to renew an edge, I keep a piece of MDF [...]

HOUSE OF DUST To keep airborne dust from getting into the house, I bought a dust collector for my basement workshop. I wanted to start with a clean slate, so I decided to rid the shop of a [...]

Here’s a quick way to glue up a mitered frame of any size using only two clamps, with no worry that the frame will shift out of alignment. You’ll need two 1″ x 1″ hardwood bars (make [...]

Here’s a quick way to get all the dust out of your machine’s nooks and crannies. Most shop vacuums have one port for vacuuming and a second port for blowing. Hook up a hose to each [...]