Bee Gone So, I’m using a wire brush chucked in a drill to clean the rust off of some old metal brackets that I’m planning to use in my new lumber rack. I’ve got a bracket in one hand and …
Who says you can’t put a square peg in a round hole? My scrap bin is made from round cardboard tubes made for concrete forms. These tubes are available at home centers; they’re [...]
Tool: 5-in-1 Combination Protractor Shop Now Manufacturer: Starrett MSRP: $142 If walls were all exactly 90 degrees, installing cabinets and trim would be a lot easier. When it comes to [...]
Rear Ended After cutting a piece of wood with my ancient radial arm saw, I turned to retrieve the pencil that I’d used to mark the cut—the saw’s vibration had caused it to roll off the table and [...]
For accurate drilling, build an engineered table. Did you know that most drill press tables are made for metalworking? Woodworkers need a better table: it should have a broad surface, an easily [...]
FRAMED The old family photograph that needed a new frame was an odd size, 10-5/8 in. by 11-3/8 in., so I knew I couldn’t buy a frame to fit. Starting with a length of straight-grained oak, I used [...]
My grandfather made this foot-powered jigsaw during World War II. The Depression had taught him to be very frugal, so he built the saw from orange and grapefruit crates, which were made from [...]
Blowin’ in the Wind My wife and I ran out of plywood as we were adding shelves to the garage, so we headed to the home center for another sheet. We hadn’t noticed how windy it was until we came [...]
Editor’s note: This article originally appeared in the October/November 2009 issue of American Woodworker The impetus for building my shop was to satisfy a passion that my late brother Glen [...]
Kick the Can When I was a boy, my dad taught me a great way to re-seal a can of stain. He would place the open can on the floor with the loose lid in position on the can, …
When buying supplies for my shop, I often visit a store where stuff costs around $1. Many items sell for much more at a home improvement store, so I save a pile of money. You never know what [...]
Having been a woodworker for well over fifty years, I knew what I wanted in a shop: an ample assembly area with plenty of natural light and my tools close at hand. As I live on a small farm, my [...]
