Tricks of the Trade

Shellac is a mainstay in my shop, both as a sealer and as a finish. I mix my shellac from flakes and usually go with a 1 lb. cut, which is ideal for brushing ultra-smooth coats. I used to measure [...]

 Here’s a trick for I use for removing a stubborn router bit from the collet. I cut 1/2″ wide slots in a few credit card-size pieces of laminate. I then slide as many cards as I can [...]

I buy glue in gallon jugs and, having tried about every glue bottle on the market, I thought I would never find the perfect one. My search ended while washing dishes with my wife one evening.  [...]

Frustrated with my vise’s inability to hold odd-shaped pieces, I tried many solutions: v-notched face plates, cork, bubble wrap, leather, etc., but to no avail. One day I pulled an old mop out of [...]

Like most people, I keep lots of different screws, bolts, nails, washers, and other small parts in bins. Instead of paper labels, I hot glue a sample of the actual part on the outside of the bin. [...]

Having grown tired of bending and tearing sheet sandpaper again and again to get the size I need, I finally decided to employ the time-honored trick of cutting it with a hacksaw blade screwed to [...]

Can you assume that a board is straight, just because you’ve jointed its full length? Nope. It can still be as bowed as ever. You really should check it before moving on to the next piece. [...]

I made my own try square using a 1″ x 4″ corner mending plate and a couple scrap pieces of hardwood. To make one yourself, first check the mending plate to be sure it’s square. If [...]

I wanted to rout some shelf dados, but I didn’t have the correct-size bit for the job. Fortunately, my dad stopped by and, as usual, had the answer to my problem. We cobbled up a couple L-shaped [...]

To sand a lot of molding, glue 80-grit sandpaper to several inches of the molding. Rub a block of Styrofoam on the sandpaper until the block conforms to the molding’s contour. Glue [...]

I don’t like to lay my router on its side with the bit exposed, so I built a stand for it. It’s just a 3/4″ x 8″ x 8″ board with a 2″ dia. hole in the center. The board …

The limited crosscut capacity of my cabinet saw made it a challenge to cut wider boards, so I designed an infeed table that hangs on a wall when not in use and quickly and securely attaches to [...]