We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
Press fitting pen parts requires a deft touch, but you don't need a special clamp or vise to do the job: I use my lathe and a pair of 1-1/2-in.-thick hardwood blocks. Each block has a 1-in.-deep hole drilled in it, sized to fit snugly over the lathe’s headstock and tailstock spindles. Remove both lathe centers and slip on the blocks. Mark the center of each block so you can precisely align the pen parts. Hold each part in place and carefully advance the tailstock.
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
