In Shop Blog

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

For several years I used CompWood for furniture parts that needed to be bent precisely. It’s a wood that has been compressed in its length under heat and with moisture. When the wood cools, it can be bent cold. No steambox. And I have yet to encounter wood failure with the stuff.

The only downside? It’s expensive compared to cutting down a tree, riving out the stock and bending it green.

A few years ago, the site where I bought the stuff closed down. It’s now available again (perhaps from the same operator) at Pure Timber.

The armbow I bent for a Welsh stick chair.

I purchased a chunk of red oak from Pure Timber to test it out and make sure it was just as good as the stuff I used years ago. Today I bent an armbow for a chair I’m making for a customer as an experiment. The armbow isn’t a particularly difficult bend with really green wood, but you do need a bending strap, a steambox and an assistant.

You need to store the wood in plastic to prevent it from drying out.

With the cold-bend hardwood, you don’t need any of those things. I was able to bend the armbow by myself using arm pressure and regular F-clamps. Now it needs to dry (I’m going to gin up a basic kiln as per the instructions at Pure Timber).

I am greatly encouraged by the experiment today. I have a special project in my design notebook that would be much easier with cold-bend hardwood. Unless something goes to pot with this armbow, I think I’m going to be able to take on this important personal project.

— Christopher Schwarz


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recent Posts
Showing 3 comments
  • Ralf

    Chris,

    Would this work with a continuous arm chair.? (form)

    What about spindles, rockers,m arms?

    If this is all possible it would be looking into.

    I like this.

    Ralph McCoy

  • comboprof

    Thanks for the link to basic kiln instructions at Pure Timber.

Start typing and press Enter to search