In Finishing, Shop Blog

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Brushing Finish

Sometimes when brushing a finish your brush will lift some of the stain leaving lighter areas.

This may have happened to you. It’s surely happened to me. When you’re brushing a finish, the brush picks up some of the stain and lightens the wood. It’s even worse when the brush picks up so much stain that it leaves streaks.

The first solution to try is to let the stain dry longer. Oil stains usually require drying overnight in a warm room, longer if the room isn’t warm. Water-based stains dry much quicker, but the drying can still be slowed by high humidity and cold conditions.

If drying for a longer time doesn’t solve the problem, it could be that the stain just doesn’t have enough binder in it to fully glue the pigment to the wood. So seal the stain in the wood by spraying the first coat of finish. If you don’t have a spray gun, use an aerosol. Aerosols containing polyurethane and water-based finish are now widely available, in addition to those containing lacquer and shellac.

Once the sealer coat has dried, you can continue brushing without disturbing the stain. For your next project, consider changing to a different brand of stain.

— Bob Flexner

FlexnerFooterC_635x72


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recent Posts

Start typing and press Enter to search

CNCs in a Workshop