In Projects, Shop Blog, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Versatile Center Gauge

I wanted to add accent dowel “dots” down the center of some slightly curved, tapered table legs. Sounds simple, but I nearly pulled my hair out trying to accurately find the center of these legs using a ruler! I was about to tick off the center of the leg every 1/4″ to get the curve I wanted.

Forget it! I came up with a clever, self-centering gauge that works on any board, straight, tapered or curved.

I drilled a snug-fitting hole for a pencil in the middle of a 1/2″ by 1/4″ stick. Then I drilled two smaller holes for 10d nails an equal distance from the pencil hole. I spaced these holes so the distance between them was a little larger than the widest section of the leg.

I placed the gauge over the tapered leg and rotated it until the nails contacted the sides. I drew the center line of the board while keeping the nails against the side. Try it, it really works!

Steve McHugh

My Take

This is such a clever, useful accessory that I’d be tempted to make it using a little thicker stock, and maybe glue in short dowels instead of nails. The thicker stock would help register the pencil vertically. Another thing that works well for holding a pencil in a gauge like this is to install a threaded insert that’s slightly smaller than the pencil’s diameter. This way, the pencil is literally threaded in; there’s no chance it will shift or slip out of the hole.


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search