In Projects, Shop Blog, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Mobile Clamp Rack

Hold it! Roll it! Hang it! Store it!

By Roger Meinen

Tired of dragging clamps around my shop, I built this rack that brings them right to the job. It takes up only 21 x 32 in. of real estate and can handle 36 adjustable clamps and 12 4-ft. pipe clamps.

I assembled the side frames separately before screwing them together with gussets at the top and a plywood shelf at the bottom. I tapered the ends of the 1x4s at the top to fit. Before installing the 3-in. swivel casters, I glued on plywood pads to reinforce the corner joints.

Each frame consists of 2×4 and 2×6 rails screwed to 1×4 ends. I ripped the 2x6s in half to make the clamp rails. I staggered the top rails so the pipe clamp rail sits higher. 

To make the half-round cutouts that hold the pipe clamps, I drilled centered holes in the 2×6 before I ripped it in half.

On the other frame, I cut slots in the rails for adjustable clamps. I cut the slots on my tablesaw, using my dado set and the miter gauge.

This story originally appeared in American Woodworker May 2005, issue #114.

May 2005, issue #114

Purchase this back issue.


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search