Editor’s note: Special thanks to reader Bob L, who pointed out that putting a rare earth magnet that close to a moving saw blade can have catastrophic consequences. If you choose to use [...]
Ordinary push pads tend to slip, I’ve found, when face-jointing a board. I modified one of mine by cutting 1/2″ of the rubber padding off its back end and then screwing on a 1/2″ x [...]
A push stick is a familiar device to prevent kickback while ripping a board, but I prefer to use a “push shoe.” It’s shaped like a shoe with a handle, and has a heel, just like a boot. The [...]
Face jointing boards requires some safety precautions to keep your fingers out of the danger zone. I made this simple push plate with a cleat on the back end. Two handles allow me to apply [...]
Tool: GRR-Rip Block Manufacturer: MICROJIG Price: $83 (pack of 2) Push blocks are essential in every shop. I’ve used my fair share of them, and the new GRR-Rip Block from MicroJig just [...]