Archives

When using my miter saw, I’ve found that the easiest way to sneak up on a line is to use a stack of sticky notes. First, set a stop block to cut your part slightly oversize (1/16″ is [...]

I use a portable circular saw to break down plywood and other sheet goods into manageable pieces before bringing them to the table saw for final sizing. I prefer to do the job on sawhorses rather [...]

The next time you use your jigsaw, forget about hauling out the sawhorses or cantilevering a hard-to-hold workpiece off your bench. Extruded polystyrene insulation board, the rigid pink sheets [...]

Strength, patience and a sharp saw turn scraps into treasure. The hardwoods I use are almost always riven or split from a log. When I need thinner pieces than usual, I split them again. But there [...]

When I was a kid, the first saw I bought was a Craftsman coping saw with a chrome frame and red-stained handle. For years I did everything with that saw – crosscuts, rips, curves and even joints. [...]

Resawing on the bandsaw allows you to cut logs into lumber, make thin boards from thick and cut your own veneer. Here's how.