Archives

Edge-Banding Clamp I ran out of clamps and patience the last time I applied a veneered edge to a long piece of plywood. The tangle of clamps to hold the veneer and cauls in place was more than I [...]

How Can I Avoid Kickback When Resawing on a Tablesaw?   Q: Is there a splitter that can be used for resawing on a tablesaw? Mine is hooked onto the blade guard so it won’t work. A: [...]

Should I Run My Tablesaw on 120 or 240 Volts?   Q: My contractor’s saw pops a breaker every once in a while, and that’s driving me crazy. I noticed that its motor can be wired [...]

Tubular Storage Here’s my solution for storing skinny things like wood trim and edge banding. I bought a 12-in.-dia. by 8-ft.-long cardboard concrete form at a home center for about $14. I [...]

Glue-Up Helper I've always struggled with the rubber bands I use to hold jewelry box sides square and steady during glue-up. The biggest pain in the neck was cleaning the glue squeeze-out [...]

Tabletop Connection Steel tabletop fasteners are a great way to attach a tabletop to its base while still allowing for seasonal changes. On a table with straight aprons, it’s easy enough to [...]

How tight does my blade have to be?   Q: I have a heck of a time loosening the arbor nut when I switch blades on my tablesaw. How hard do I really have to crank on that nut when …

Double-Duty Roller Tables I like getting double duty out of my tools whenever possible. So, when I decided to build outfeed tables for my miter saw and tablesaw, I worked up this dual-use [...]

Tablesaw Sled Cutoff Block My sliding cutoff sled gets lots of use for repetitive cuts. In the past, I clamped a board to use as a stop, but moving it for different cuts became cumbersome. To [...]

Getting the Point I frequently use awls in my work and like to keep them needle-sharp. This little jig takes only a few minutes to make and guarantees a fine, tapered point. The magnets keep the [...]

Do Blade Stiffeners and Stabilizers Really Help?   Q: I’m trying to get a super-smooth cut on my contractor’s saw. I’ve seen blade “stabilizers” for sale. Do [...]

Cross-Grain Trim I recently needed to attach molding across the sides of some bookcases. Because the sides were solid wood, I had to allow for some seasonal movement. I used a table-mounted [...]