Archives

I use a piece of painter’s tape to mark dadoes when I assemble cabinets. Then I know exactly where to shoot nails or install screws and there aren’t any pencil lines to sand off when I’m [...]

When my bench’s tool tray fills up with sawdust and hardware, I’ve found that the easiest way to clean it is to use a vacuum. To keep the hardware from going into the vacuum, I cover [...]

If you use a cyclone dust collector, you’ve no doubt struggled with emptying the barrel. When it’s filled with dust, it’s really heavy, not to mention the face full of dust you [...]

Large plastic boxes, the kind that restaurants use for bussing dishes, are perfect for shop drawers. They’re strong, durable and lightweight, plus they have built-in handles. They’re perfect for [...]

Maximize your drum sander’s potential. 1. Skip the Scrape Eliminate laborious hand scraping of dried glue: contrary to popular belief, you can take glue-ups directly to your drum sander. [...]

How do you know when your miter gauge is set exactly at 90°? Here’s a method I learned years ago, before I could afford a precision square to check the cut. You’ll need a 24″ [...]

The blade of a marking gauge must be as sharp as a scalpel in order to cut a fine line across the grain. Sharpening it can be very difficult because it’s so small. I solved that problem by [...]

When using my miter saw, I’ve found that the easiest way to sneak up on a line is to use a stack of sticky notes. First, set a stop block to cut your part slightly oversize (1/16″ is [...]

Wiping is fast, almost as fast as spraying (without the downside of having to clean the spray gun). Wiping is also every bit as effective in all situations except possibly into recesses such as [...]

Dust is a real problem when you can’t use a router table’s fence and its dustport. Here's a clever way to suck up that dust using your shop vacuum's nozzle.

I used to have three shooting boards for planing end grain: one for 90° cuts, one for 45° horizontal miters and one for 45° vertical miters. Now I’ve combined them all into one. The jig’s main [...]

 Here’s a trick for I use for removing a stubborn router bit from the collet. I cut 1/2″ wide slots in a few credit card-size pieces of laminate. I then slide as many cards as I can [...]