Magnetic Clamping Blocks

Difficult glue-ups are troublesome enough without having to position clamp pads as part of the process. I’ve tried using hot-melt glue, double-sided tape and various other methods to hold pads [...]

Chemical Ebonizing

A sure-fire recipe for turning any wood deep black. Remember the old ad slogan, “better living through chemistry”? When it comes to turning wood black—a process called ebonizing—I prefer the [...]

Cabinet Jacks

I usually work alone, but when I install upper cabinets, I always enlist the help of two shop-made cabinet jacks. They’re steadier than an extra pair of hands. The jacks stand on the lower [...]

Tenon Preview

A tenon should be one-third the thickness of a rail—at least, that’s what an old rule of thumb recommends. A 3/4″ board should have 1/4″ tenons, for example. But what about a [...]

Sawing a Log into Salvaged Holly Lumber

Having lived in our house for over three years now, we’ve had to make some difficult decisions about our trees. Unfortunately, we had to fell a few trees upon moving in, including some sick [...]

The Science of Wood Glue

Delve into the characteristics and properties of the 7 families of glue and adhesives. OK, so you consider yourself a woodworker. Let’s say that your neighbor asks you what appears to be a simple [...]

Clamp Spacers

While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They [...]

The Wedged Mortise & Tenon

This time-tested joint is perfect for knockdown furniture. This bedstead I’m building is a perfect place to use a joint that I rarely cut: the wedged, through-mortise and tenon. I need to be able [...]

No-Fuss Flush Trimming

My flush-trimming setup allows trimming veneer and solid wood edging up to 7/8-in. thick. It consists of a router with a 1/2-in. straight bit, a table and a perpendicular fence. A 1″-thick [...]

Cork Vise Facing for a Soft Touch

I’ve found that padding my vise faces with cork prevents them from marring many surfaces, especially softer woods or finished workpieces. I use 1⁄4“-thick cork, which is available by the [...]

Whittling Basics, Part 6

Attach the tree to the base. Part 1: Introduction • Part 2: Push and Peel Knife Maneuvers • Part 3: Parting and Pulling Techniques • Part 4: Rounding the Tree • Part 5: Sculpting the Branches Now [...]

Start typing and press Enter to search