As a sawyer, I always have a few questions for a client as I prepare to saw their logs into lumber. The first is: “How do you want this cut…live edge or boards?”. My second [...]
Check out these 11 methods to make layout easier. Write With Chalk Lay out “cut here” marks on rough lumber with chalk. Chalk marks are easy to read, even on the scruffiest surface. Unlike ink, [...]
Your joints will last for decades if you know how to apply your glue. Much of woodworking is joinery: An edge-to-edge joint is used to join two or more boards to create a tabletop, dovetails are [...]
I re-sharpen disposable planer blades a few times, using a shop-made jig, before tossing the blades away. I use a set of three diamond hones to sharpen the blade at an angle 5° higher than the [...]
Editor’s note: This dovetail method is referenced in the October 2021 issue of Popular Woodworking, so we are republishing it to the home page. The blog below was originally published in [...]
I recently thought I’d outfit my portable “benchtop” table saw with a zero-clearance throat plate to reduce tear-out and to prevent narrow strips from falling down through the wide throat [...]
My portable planer uses disposable blades. When the first set got dull, I didn’t throw them away–I turned the two blades into very useful drawknives. I wrapped duct tape around the ends of the [...]
I made a built-in bookcase for my daughter that required attaching the face frame after installing the case. I didn’t want to mar the face frame with nail holes, but I don’t have any [...]
I previously wrote about several types of hinges commonly in use and described various techniques for installing them. For the second article in this series, here are five hinges with more [...]
A push stick is a familiar device to prevent kickback while ripping a board, but I prefer to use a “push shoe.” It’s shaped like a shoe with a handle, and has a heel, just like a boot. The [...]
Occasionally while woodworking, we all find the need to work on tapered parts. But how do you hold those parts in a vise or with a clamp in order to do the work? I saw a product in a …
