Archives

Like most people, I keep lots of different screws, bolts, nails, washers, and other small parts in bins. Instead of paper labels, I hot glue a sample of the actual part on the outside of the bin. [...]

Having grown tired of bending and tearing sheet sandpaper again and again to get the size I need, I finally decided to employ the time-honored trick of cutting it with a hacksaw blade screwed to [...]

Can you assume that a board is straight, just because you’ve jointed its full length? Nope. It can still be as bowed as ever. You really should check it before moving on to the next piece. [...]

I made my own try square using a 1″ x 4″ corner mending plate and a couple scrap pieces of hardwood. To make one yourself, first check the mending plate to be sure it’s square. If [...]

I wanted to rout some shelf dados, but I didn’t have the correct-size bit for the job. Fortunately, my dad stopped by and, as usual, had the answer to my problem. We cobbled up a couple L-shaped [...]

To sand a lot of molding, glue 80-grit sandpaper to several inches of the molding. Rub a block of Styrofoam on the sandpaper until the block conforms to the molding’s contour. Glue [...]

I don’t like to lay my router on its side with the bit exposed, so I built a stand for it. It’s just a 3/4″ x 8″ x 8″ board with a 2″ dia. hole in the center. The board …

Bench grips are handy for holding parts above the bench for routing, sanding or finishing.  To make them, just cut some wood and rubber shelf liner into 2″ to 3″ squares. Glue the [...]

Good light is a must in every workshop, but sometimes I need a little extra light in just the right place. To make my light/magnifier more portable, I drilled a hole in a handscrew to fit the [...]

Instead of measuring for my circular saw’s offset each time I need to make a cut, I use a modified edge guide. I screwed two 3/4″ x 3/4″ x 12″ hardwood blocks to the front and [...]

Let’s face it: running a twisted board through the planer doesn’t make it flat. The board will still be twisted when it comes out. The trick is to use a sled that prevents the board from rocking [...]

To support a large panel while I drilled holes in the edge for dowels, I added a second sliding clamp jaw to a pipe clamp and clamped it to the edge of my workbench. -Steve Keller…