Archives

My task: 28 kitchen drawers of different sizes, all with hand-cut dovetails. The thought of laying these out was overwhelming, so I designed a jig to simplify the process. To make the jig, [...]

Any push stick adds a measure of safety, but I prefer using one that straddles the saw’s fence. It lifts right off when I’m done. A saddle-style push stick has two clear advantages. First, [...]

  Tips for taming those awkward and heavy sheets. Woodworking alone is peaceful, serene and quiet. Just you, the radio and your project. It’s also a pain in the posterior when you have to [...]

A complex moulding can be difficult to sand. Softening its crisp edges is a crime, so I’ve been using a thin, flexible stick with sandpaper adhered to it for getting into the flat areas. [...]

When sawdust got packed into the back end of my planer’s blast gate, I couldn’t close the gate all the way.  I solved this annoying problem by cutting a notch in the gate. Now, when I close the [...]

Tighter Corner Joints Ahead Dadoes and, rabbets are two of the most widely used cabinetmaking joints. Cabinet carcasses, drawer boxes and jewelry boxes all lend themselves to this simple but [...]

Difficult glue-ups are troublesome enough without having to position clamp pads as part of the process. I’ve tried using hot-melt glue, double-sided tape and various other methods to hold pads [...]

I usually work alone, but when I install upper cabinets, I always enlist the help of two shop-made cabinet jacks. They’re steadier than an extra pair of hands. The jacks stand on the lower [...]

A tenon should be one-third the thickness of a rail—at least, that’s what an old rule of thumb recommends. A 3/4″ board should have 1/4″ tenons, for example. But what about a [...]

While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They [...]

My flush-trimming setup allows trimming veneer and solid wood edging up to 7/8-in. thick. It consists of a router with a 1/2-in. straight bit, a table and a perpendicular fence. A 1″-thick [...]

My dust collector, though pieced-together, is the perfect solution for my one-car garage shop. I use a cyclone separator and 5-gallon bucket in conjunction with my shop vacuum. For easy mobility, [...]