We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
C-clamps can make nasty dents that are tough to sand out. Pads or block will prevent this, but they’re often awkward to hold in place while you tighten the clamps. I make pads that don’t require extra hands.
I bought a roll of 1-inch wide adhesive-backed magnetic strips from a craft store and cut off a number of long lengths. I adhered these strips to 11/4″ wide pieces of 1/4″ plywood. Using a miter saw, I cut these pieces into shorter lengths as needed to fit the C-clamp jaws. I store my magnetic pads on a steel strip that I screwed to the end of the bench. The pads are ready to go whenever I need them.—Peter Smith
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
