In Tricks of the Trade

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Spring clamps are easily converted to miter clamps by adding swivel jaws. Remove the vinyl tips, and then hacksaw a 1/2″ long slot down the center of the metal jaws. Use needle-nose vise-grips to fold down the two halves of each jaw, and then drill a hole for a small bolt or rivet.

To make the swivel jaws, snap off two pieces of an old hacksaw blade 3/4″ – 1″ long.  Drill holes through their centers and fasten them between your spring clamp’s folded tips. For extra holding power, double the blades at each tip. Make sure the teeth point towards the clamp’s mouth for maximum gripping power. –Bert Herrick


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search